Products

• Submersible Borehole Pumps
• Submersible Borehole Motors
• Boreline Flexible Rising Main
• Starter/Control Panels
• Borehole Accessories
  • PVC Motor Shroud
  • Submersible Cable Joint Kit
  • Steel Well Heads
  • Power Cables
  • Starter/Control Panels
• Flowmeters
• MWR Diesel Generators

Services

• Introduction
• Borehole / Pump Servicing
• Precision Engineering

A range of four heat-shrink submersible cable joints is available, covering cable sizes 1.5 to 25mm² - kits contain all necessary joint components, cleaning materials and comprehensive instructions.

Four kits available -
for 1.5 to 2.5mm², 4 to 6mm², 10 to 16mm² & 25mm² Cables

EACH KIT CONTAINS : - Adhesive-Lined Heat-Shrink Tubing (400mm) 4 x Heat-Shrink Cable Crimps Sealing Mastic (1.5m roll) Emery Cloth (120 grit) Electro-Wipes Ruler All supplied as a complete packaged kit with comprehensive instructions STANDARD WORKSHOP EQUIPMENT REQUIRED : - Sharp Knife / Wire Cutters Crimping Tool / Heat Gun

1. Read and understand the full instructions supplied with the kit.
2. Trim motor & power cables to remove any damaged ends and cut the outer sheath back to expose individual cores.
3. Using the emery cloth and electro-wipes scour / clean all cable surfaces to ensure correct adhesion of the mastic and sleeve.
4. Cut individual cores to lengths indicated on the dimensioned sketch provided - the ruler can be used to check dimensions.
5. Place the outer heat-shrink sleeve over the power cable and slide clear of the working area. Strip back the inner sheath from each core and join them using the cable crimps - ensuring that cable colours match correctly.
6. Work the mastic between/round the cores and fully into the joint to exclude any air pockets before rolling it to a neat 'sausage'.
7. Centralise the heat-shrink sleeve over the joint and heat until the whole sleeve has shrunk to the a tight fit on the cable & joint.

Note : Modified procedures for motors with individual tails are fully detailed in the kit instructions.